Professional Replacement Liquid for Red Blue Vision 3rd Generation Headlight Lamp. Restores and regenerates car headlights to their original condition and lasts for more than 3 years. The professional 800g liquid is sufficient for approximately 22 car headlights.

Application procedure:

• Mask the area around the headlights with masking tape.
• Sand the headlights with wet sandpaper and water, starting from P320 or P600 depending on the condition of the headlights.
• Continue with sandpapers P800, P1000, P1500, P2000 & P3000.
• Sanding should be thorough and uniform across the entire surface of the headlight.
• Place the liquid into the lamp above the middle of the container to avoid the risk of the heating element burning out.
• Close the heating container with one of the two lids and wait about 4-5 minutes for the liquid to boil.
• When you see the steam start coming out of the nozzle, bring the headlight at a distance of about 5cm, starting from the bottom to the top with a horizontal movement left to right, moving slowly without leaving gaps.
• In less than a minute you are done and after 10 minutes the headlight is ready.

Attention: Always wear gloves, mask, and protective glasses during use.