Category: Heating Elements

• Power supply: 230V/50Hz
• Power: 200W-1000W
• Operating temperature: 0～55℃
• Temperature adjustment range: 30 –70℃ (5℃ adjustment)
• Operating modes: Standby / water temperature setting with 2H/4H/6H/8H timer
• Memory function
• Insulation class: Class I
• Waterproof rating: IPX4
• Dimensions: 70 x 60 x 45 mm

Installation on bath body:

• The device should not be screwed or unscrewed from the plastic part of the device.
• The device should not be installed horizontally or facing downward.
• Do not fill the bathtub body to the top edge with water, as swelling will occur once the temperature rises.
• Water with antifreeze or proper type of oil can be used as a heat carrier.
• The bath body should only be heated by the resistance. Do not place the resistance parallel to the heating system.

Electrical resistance:

• The device should not be connected to power during installation.
• Place the resistance at the lower part of the bath body.
• Screw the electric resistance into the bath body by turning the base with a size 22 wrench.
• Ensure that the connection between the resistance and the body is tightly secured.

Removal:

• If the body is already installed in the central heating network, shut off the valves and remove any liquid inside before installing the electric resistance. You may need to flush the body to clean it from existing muds and metal sediments.