High Voltage Arc Generator 15KV

Product Introduction:

• Dimensions: 29*24*18mm
• Requires 12V, with resistance base adjustment from 150 ohm to 1.5K ohm.
• The resistance should vary from high to low, without being too low to avoid burning the triode or the product.
• It should not be too high, as it will affect the output performance.
• Maximum output: 15kV, with a limited output that must not exceed 15kV (arc 1.5cm) to avoid product damage.
• The use of wax or epoxy resin insulation is recommended for continuous operation.

Features:

• Easy construction with a simple and reliable circuit design.
• Uses: experiments, electronic devices, negative ion generator, small scientific productions.
• Creates a stable high-frequency arc that can ignite flammable materials.

Parameters:

• Transformer dimensions: 27×16×21mm
• Input: DC 3.7V-4.2V (maximum 12V, requires resistor adjustment).
• Input current: <2A
• Output voltage: approximately 15KV.
• Output current: ≤0.4A
• Ignition distance: ≤0.5 cm

Deletion and Layout:

• Two primary coils and one feedback coil.
• The PCB dimensions are: 4.2CM * 3.2CM * 0.16CM.

Includes:

• 15VKE step-up transformer x1
• PCB Board x 1
• Resistor 120 ohm x 1
• UF4007 fast recovery diode x 1
• Triode N20 x 1
• Heatsink x 1
• M3 * 6 screws x 1
• Switch x 1
• 3-Pin x 1