Instructions for Use:
Preparation for use:
Charging the device: Make sure the jump starter is fully charged before use. Connect the jump starter to a power outlet with the appropriate charger (if included).
Check the ports: Ensure that the jump starter's ports are clean and dry.
Using the jump starter:
Connect the cables:
Connect the red cable to the positive terminal of the car battery.
Connect the black cable to the negative terminal of the battery.
Connect the jump starter:
Connect the corresponding cables of the jump starter to the two terminals of the battery (red to positive and black to negative).
Starting the car:
Turn the car key to start the engine.
After the car starts, disconnect the cables in reverse order (first the black, then the red).
Using the air compressor:
Connect the air compressor: To use the air compressor, make sure it is connected to the charging port or the appropriate output.
Set the pressure: Adjust the pressure on the air compressor according to your needs (e.g. car tires). Maximum pressure up to 150 PSI.
Activate the air compressor: Press the power button to turn on the air compressor and monitor the pressure until it reaches the desired level.
Using the flashlight:
Press the button connected to the flashlight to turn it on.
Press again to change mode (steady/blinking).
Precautions:
Do not expose the jump starter to moisture or water.
Do not use the device for purposes other than those specified.
Avoid overcharging or overheating the device.
Maintenance:
Regularly check the condition of the cables and the device.
Store the product in a cool and dry place.
Package Contents:
1 Jump Starter
1 Set of Jump Starter Clamps
1 Air Hose
3 Nozzle Adapters
1 USB Cable
1 Carrying Case
User manual