Rolling Pin Madness of Cthulhu A rolling pin with a texture that allows the impression of a continuous repeating pattern on clay and putties. Made from clear PMMA plastic with non-stick properties. Non-toxic.

• Length: 14.50 cm (5.5 inches)
• Diameter: 2.5 cm (1 inch)
• Pattern size: variable with multiple types of bricks, cursed runes, and different Chuttlu patterns.

Instructions for Use:

• Mix the putty/clay correctly according to the manufacturer's recommendations.
• Spread the putty/clay on a smooth surface to create texture.
• Wet the rolling pin if needed, to avoid sticking.
• Through slow movements, apply equal pressure for uniform texture.
• Trim the peripheral putty/clay with a sharp knife.

Materials: There are many different options for putties and clays that can be used. Polymer clay (Fimo or Sculpey type) is ideal for working with the rolling pin.

For textured bases, the use of MDF bases is recommended. The baking time for these clays is about 15 minutes at 150ºC.

For epoxy putties, you can apply directly to plastic bases, without needing baking. Use water or talcum powder to reduce the sticky texture if needed.

Care Instructions: After completing the use of the rolling pin, clean it with a brush and plenty of water for any residues.