Car Battery Jumper Cables 500Amp – 2m

Features:

• Heavy-duty copper cables with fully insulated clamps.
• Available in 2 colors for easy identification: black and red.
• Ideal for general use on medium and large vehicle batteries.
• For connection to the positive and negative terminals of the battery.
• Length: 2m.
• Power: 500Amp.
• Comes in a practical zippered storage bag.

Usage:

• Connect one of the red clamps to the (+) terminal of the dead battery and the other red clamp to the (+) terminal of the booster battery.
• Connect one of the black clamps to the (-) terminal of the booster battery and the other black clamp to the ground of the disabled vehicle.
• The ground connection should be as far away from the battery as possible.

Jump Starting:

• After connecting the jumper cables, start the engine of the booster vehicle.
• Then, start the engine of the disabled vehicle.
• After each starting attempt, which should not exceed 15 seconds, wait at least 1 minute before trying again.
• Once the engine of the disabled vehicle starts, wait 2 to 3 minutes until it runs normally.

Disconnecting:

• Disconnect the jumper cables in the reverse order of connection.
• Remove the black clamp first that is connected to the ground of the disabled vehicle.
• Then, disconnect the other black clamp from the (-) terminal of the booster battery.
• Next, disconnect the 2 red clamps in any order.
• When removing the jumper cables, ensure they do not come into contact with the moving parts of the engine.

Warning! For vehicles equipped with START-STOP, consult the manufacturer's manual.