Easy installation by removing the two screws of the mask and with a wire I made with two hooks and pulling downwards it came out immediately as shown in the photos! The windshield leaves gaps especially on the inside, although they are not visible when you are driving! Personally, the plastics do not rattle nor does the windshield, I tested it without a helmet on purpose, now at high speeds I haven't tested it yet! It looks nice and is of quality construction, the only thing that bothers me is that I didn't get the dark tinted one because I was afraid I wouldn't be able to see at night, but in the end, with a height of 1.75, I can see just fine over it.

It is beautiful, cuts the air nicely and is of good quality BUT it does not fit properly and leaves a little gap that wouldn't bother me aesthetically at all if it didn't bring the many creaks from the plastics that do not fit properly.

Good height cuts the air at the chest. It does have the expected noise at higher speeds. If your hands are a bit skilled, it goes in relatively easily. The only difficult part is closing the plastic at the front at the end! Also, it doesn't fit exactly, and the plastic remains slightly open as others have mentioned. Don't get dark; better to choose tinted or clear; I got tinted, and it looks very nice. After a few months, it started to creak when you move it. It hasn't had any other problems so far. Inside, there are screws, nuts, etc., and installation instructions. Overall, it's good and beautiful; I would buy it again.

Edit: After 1 year, everything remains as I said above. At speeds of 90+, however, it is very noisy. My height is 1.85