The patch has a special adhesive on the back that is activated by the heat of the iron.

1. Preparation: Place the garment on a hard and flat surface (ironing board). Make sure the area is clean and dry.

2. Placement: Place the patch over the tear with the adhesive side facing down.

3. Ironing: Set the iron to the temperature for cotton (approximately 150°C-180°C) without steam. Press the patch firmly for 20-30 seconds.

4. Cooling: Let the garment cool completely for at least 5 minutes before moving it, so the adhesive can "set".

• Protection: It is advisable to place a thin cloth (e.g., a cotton towel) between the iron and the patch to prevent the fabric of the garment from "shining" due to the heat.

• Washing: After application, it is best to wash the garment inside out and at a temperature of up to 40°C to avoid damaging the adhesive.

Note: If the garment is made of material that cannot withstand ironing (e.g., nylon or very thin synthetic fabric), heat bonding may burn it. In this case, it is preferable to sew it.