Let's first say a few words about the machine and then about the painting. The compressor is what produces the air and sends it through the hose to the spray gun. The motor makes quite a bit of noise. In a closed space, it will be a bit much for your ears along with a high-pitched whistling sound it makes.
As soon as we press the switch, the motor starts working and constantly sends air to the spray gun, even if we don't pull the trigger. By pulling the trigger, it starts to draw paint from the container and sprays it. Releasing the trigger stops the paint, but air continues to come out under pressure, so the motor only stops with its switch.
The spray pattern is a fairly wide fan. By turning the front ring 90 degrees, we orient the fan from horizontal to vertical. At 45 degrees, instead of a fan, it sprays in a circle. Unfortunately, we can't adjust the fan width as you can with guns from other companies, so I "deducted" one star for that.
The cleaning kit is very good, the spare nozzle for thicker paints, and the little cup to measure the paint's viscosity (how thick it is). You dip it fully into the paint, and once it's filled to the top, you lift it and measure the time it takes to empty completely. Up to 25-30 seconds is ideal paint for spraying. From 30-60 seconds, it will be a bit difficult but will probably work. If it takes more than 1 minute to empty the cup, the paint definitely needs thinning with water (if it's water-based) or white spirit if it's oil-based.
Now, for painting, it does an excellent job. You need a rhythm and successive sweeping of the surface with slow up-down or right-left movements in strips, each strip overlapping the adjacent one by 50%. With use, you'll find the ideal distance (depends on the type and fluidity of the paint).
It's ideal for outdoor spaces, for fences, pergolas, decks, wood in general with impregnating varnishes, railings, exterior walls, etc.
For indoor spaces (at least for me), I would avoid it. It creates a lot of mist (which is, after all, its operating principle) that does stick to the surface you're painting, but about 10% remains suspended in the air. These microdroplets are either inhaled (so DEFINITELY wear a mask) or drift and settle wherever they want (and not where you want). This means you need very meticulous covering with tape, plastic, cardboard, etc., of all surfaces you don't want to accidentally paint. But this way, you lose the unique advantage of air painting, which is speed, because the time it takes to cover the free surfaces will be more than if you painted traditionally with brushes, rollers, etc. (unless you're painting the whole house a la Mr. Bean :-)
Of course, at the end of each job, very good cleaning with water for water-based paints and solvent for solvent-based ones.
Among the accessories, there is also a T-shaped plastic tool for removing the needle. Don't try it because it's most likely the needle will break and then you'll have to throw away the gun. It cleans just fine without removing the needle (fortunately, though, there is a relatively cheap spare).